Description
This is the Clifford 2025 USB-C Version of the HackRF compatible with the H2M and H4M portapacks.
This is a Standalone Board! it does not come with a case or with the portapack. It is being sold separately as an upgrade mod.
This is a parallel evolution from the “R5 Revision” HackRF board with protections on the RF input with a USB-C interface instead of the legacy MicroUSB that previous revisions included.
What’s Included:
- One (1) Clifford USB-C HackRF Board with Clock SMA Jacks Unsoldered
- Two (2) SMA jacks that can be soldered onto the clock pads on the bottom if it is desired
What’s needed for installation (not included!):
- An appropriate screwdriver (Phillips, etc.)
- A soldering Iron (if you wish to solder on the SMA Jacks prior to installation)
- Patience
Installation Instructions:
- Remove the 4 Screws from the front cover of your HackRF H2M/H4M
- Remove the Front Faceplate.
- Separate the PortaPack from the HackRF board by gently pulling the boards apart slowly (try not to bend the pins)
- Remove the 4 screws from the back cover of the HackRF H2M/H4M
- Remove the retaining nut from the Antenna SMA connector
- Loosen the retaining nuts on the Clock IN / Clock OUT ports on the bottom of the HackRF
- Remove from Casing.
- Install the new board, and repeat steps above in reverse order to reassemble.
You will need to flash the latest HackRF Firmware onto the board using DFU Mode. The board is UNFLASHED by default. No support is provided for flashing the boards.
Disclaimer:
Please note – This product is not made by Great Scott Gadgets. It is a community based Board made by a 3rd Party not associated in any way nor supported by GSG. The trademark “HackRF” is used with permission.
Rabbit-Labs is not responsible for any damages caused by the improper installation or modification of your H4M/H2M device. By purchasing this product, you understand that this is a “modification” aka “mod” to your device, and you are performing the installation at your own risk. Device should be used in accordance with all applicable laws, and only on frequencies you are authorized to use. You are responsible for the legal use of this device.
Each unit is tested and sealed prior to shipping. Other than damage caused by shipping, a 20% restocking fee (plus return shipping) will apply for any product returns of this item if the packaging is cut open and/or seal is broken. No Exceptions.
