Fully Assembled Clifford Heath Version HackRF with PortaPack H2M Authorized Signature Edition and 10.00MHZ TCXO
Clifford Heath's Github link: https://github.com/cjheath/hackrf
Added protection against excessive RF at the antenna port (Tx and Rx),
Updated receive and transmit LNA
Improved Bias-T performance
Updated other components to current-production parts (RF switches, USB & CLKIN/CLKOUT protection)
The Specific hardware improvements in the March 2024 release notes:
Added strong protection to the antenna port using the SMP1330-085LF. This is designed to provide protection for both the transmit amplifier and the receive LNA.
Improved the Bias T so it operates well at a much higher frequency, which should improve RF sensitivity (whether the bias T is enabled or not).
Replaced the seven SKY13350-385LF parts with SKY-13453-385LF (current production part)
Replaced the two MGA-81563-TR1G MMIC amplifiers with TRF37B73 (current production part)
Updated protection on the USB port with current production USB6B1 not LXES15AAA1-100
Updated protection on CLKIN and CLKOUT with current production BAS70 not LXES1TBCC2-004
Reduced the number of drill sizes from fourteen (14) down to six (6), with all vias being 27/13 mil, to make the PCB cheaper to produce.
Added two extra fiducials to help parts placement.
PortaPack Features:
PortaPack H2M is the official co-branded licensed version
PortaPack H2M adds a 10.00MHZ TCXO FOX 5070 crystal oscillator
Supports GPS simulation
Supports the latest official firmware upgrades!
3.2 Inch Upgraded Resolution LCD screen with improved touch response.
Microphone has been pre-installed.
Maximum 3W speaker amplifier Built-IN and can be used with an earphone. An internal speaker (up to 3W) can be added as well.
Upgraded battery socket and Pre-installed with a built-in 2000mAH lithium battery. (Most other units come with 1000-1500mAH maximum)
Micro USB charging and charging status LED display.
Crystal oscillator has been upgraded to a low phase noise 10.00MHZ TCXO FOX 5070 crystal oscillator. (https://abracon.com/fox-clipped-sine-wave-tcxos)
Supports GPS simulation
Upgraded Buttons to produce a better response and feel when pressing
Hackrf One Specifications:
1 MHz to 6 GHz operating frequency
Half-duplex transceiver
Up to 20 million samples per second
8-bit quadrature samples (8-bit I and 8-bit Q)
For GNU Radio, SDR#, and the like
Software-configurable RX and TX gain and baseband filter
Software-controlled antenna port power (50 mA at 3.3 V)
SMA female antenna connector
SMA female clock input and output for synchronization
Convenient buttons for programming
Internal pin headers for expansion
Hi-Speed USB 2.0
USB-powered (MicroUSB)
Open source hardware
Special Notes:
It has been assembled and tested in the USA by Rabbit-Labs and is ready to Flash.
It includes a RABBIT-LABS BRAND SD CARD. These are not the cheap Fake SD cards that have plagued many other PortaPacks found elsewhere!
Custom Rabbit-Labs Background will be included on each SD Card
It comes UNFLASHED. You must flash a firmware of your choice onto the unit. We cannot advise you on which firmware to use.
Made with ROHS processes
Disclaimer:
It is your responsibility to use this device in a legal manner. It is meant for educational and research purposes only. Depending on your jurisdiction it may be illegal to transmit or use this device without a license. Prior to purchasing this device, please ensure it is legal for you to own or operate such a device. We are not responsible for your failure to research this prior to purchase and cannot provide a refund or support if your use is in violation of local laws. Also – We are not lawyers, we cannot provide you legal advice. If you are unsure if you can operate or own this device, please seek legal advice from a licensed attorney.
