Skip to content

Rabbit-Labs 2500mAh LiPo Battery for PortaPack // 3.7V 9.25Wh // HackRF H2, H2M, H4M, H4R + Marauder v7

$17.56

HSCODE
8507.60.0000
ECCN
EAR99

In stock

Frequently Purchased Together

Rabbit-Labs 2500mAh LiPo Battery for PortaPack // 3.7V 9.25Wh // HackRF H2, H2M, H4M, H4R + Marauder v7
+
PortaPack Metal Screws
Total: $23.95

Description

▌PRODUCT DESCRIPTION

>> CUT THE USB CABLE. TAKE THE SPECTRUM WITH YOU. <<

A HackRF with a PortaPack is a full software-defined radio in your hand: screen, controls, firmware, the whole band from a few MHz up into the gigahertz. Then you notice the USB cable running back to a power bank in your pocket, and the illusion breaks. Or worse, the internal battery that came with it taps out before the session does.

The Rabbit-Labs 2500mAh LiPo Battery is a custom-built 3.7V, 2500mAh, 9.25Wh single-cell pack made for the PortaPack. It drops into the H2, H2M, H4M, and H4R with the standard 2-pin connector, no splicing and no adapters.

Maximum capacity for the case. 2500mAh is the largest battery that fits inside the standard PortaPack metal enclosure, so you’re getting all the runtime the case can hold. On an H2 that works out to roughly 4 to 5 hours of real use per charge, depending on what you’re running.

Protected at the cell. An onboard protection circuit with low-voltage shut-off cuts the pack off before it can be drained into damage, along with overcharge and short-circuit protection. Your PortaPack charges it over USB the way it was designed to.

Key Specs:

  • Compatibility: HackRF PortaPack H2, H2M, H4M; JCMK ESP32 Marauder v7.2 (see polarity note)
  • Chemistry: Lithium polymer (Li-ion), single cell
  • Nominal Voltage: 3.7V
  • Max Charge Voltage: 4.2V
  • Capacity: 2500mAh
  • Energy: 9.25Wh
  • Cell Size: 104050
  • Protection: Overcharge, over-discharge (low-voltage shut-off), short circuit
  • Connector: 2-pin PH2.0 JST, red (+) / black (-)
  • Dimensions: approx. 10.4 x 40 x 50 mm (0.41 x 1.57 x 1.97 in)
  • Weight: approx. 45g (1.6 oz)
  • Transport Testing: UN38.3 tested, ships at approx. 30% charge

Applications that matter:

  • PortaPack in the Field. Untether your HackRF and PortaPack for spectrum surveys, signal analysis, and RF research wherever the work takes you.
  • Replacement & Upgrade. Swap out a tired stock cell, or upgrade a PortaPack that shipped with a smaller battery to the full 2500mAh the case allows.
  • JCMK ESP32 Marauder v7. Now compatible with JCMK’s Marauder v7. All v7 units sold since October 15, 2025 are hardware revision v7.2, with connector polarity matched to Rabbit-Labs batteries. Check the device out at justcallmekokollc.com.

2500mAh. Full case. No tether.


▌README.TXT – INSTRUCTIONS FOR USE

Compatibility: Fits the HackRF PortaPack H2, H2M, and H4M with the standard 2-pin battery connector. The original PortaPack H1 has no battery support and cannot use this battery. Also compatible with JCMK’s ESP32 Marauder v7.2. Earlier Marauder v7 units have reversed connector polarity, so check yours before connecting.

Step 1: Power Down Turn the PortaPack off and unplug USB power. Open the enclosure following your PortaPack’s disassembly instructions.

Step 2: Remove the Old Battery If a battery is installed, unplug it from the board by gripping the connector housing, not the wires. Remove it gently using plastic tools only. Never pry with metal or sharp tools, and never bend or puncture the old pack.

Step 3: Check Polarity Compare the red (+) and black (-) leads with the + and – markings at your board’s battery connector before plugging in. Reversed polarity can permanently damage your device.

Step 4: Install Seat the battery flat in the enclosure, routing the leads so they won’t be pinched when the case closes. Plug the connector in straight until it seats fully.

Step 5: Close & Charge Reassemble the enclosure. The battery ships at approximately 30% charge, so charge it fully over USB before heading out. Expect about 3 to 4 hours for a full charge, depending on the cable and power source.

Step 6: Operate Power on and go. The protection circuit shuts the pack off at low voltage. Recharge as soon as you can when the PortaPack reports a low battery.

PRO TIP: Charge from a good wall adapter or power bank with a short, quality USB cable. Long or cheap cables noticeably slow PortaPack charging.


▌DEBUG LOG – TROUBLESHOOTING

ISSUE: PortaPack won’t power on from battery. FIX: Check the connector is fully seated and polarity matches the board markings. The battery ships at about 30%, so charge over USB and try again. If the pack was run completely flat, the protection circuit may have tripped. Plugging into USB power to charge resets it.

ISSUE: Battery won’t charge or charges very slowly. FIX: Try a different USB cable and power source. Short, quality cables charge noticeably faster. Confirm your PortaPack model has battery charging; the original H1 does not.

ISSUE: Runtime is shorter than expected. FIX: Transmitting, high screen brightness, and processor-heavy apps all draw more power. A new battery may also take a few full charge cycles before the battery meter reads accurately.

ISSUE: Case won’t close flush. FIX: Reroute the leads so they aren’t pinched, and make sure the pack sits flat. 2500mAh is the largest battery the standard enclosure holds, so the fit is snug by design.

ISSUE: Marauder v7 won’t power on with the battery. FIX: Units sold before October 15, 2025 may have reversed connector polarity. Do not force a connection. Check polarity against the board markings first.

ISSUE: Battery is swollen, hot, or smells sweet or chemical. FIX: Stop using it immediately. Disconnect it if you can do so safely, move it to a non-flammable area, and take it to a battery recycling drop-off.


▌SYS.WARN – WARNINGS, HAZARDS & DISCLAIMERS

Lithium Battery Hazard. Lithium polymer batteries can catch fire, vent, or explode if punctured, crushed, short-circuited, overcharged, or overheated. Misusing or mishandling lithium batteries can cause serious personal injury, property damage, or death. The user must understand how to handle lithium batteries safely before purchase.

Polarity. Check connector polarity against your device before connecting. Reversed polarity can permanently damage your device.

Charging. Charge only through your device’s built-in charging circuit or a charger designed for single-cell 3.7V lithium polymer batteries (4.2V max). Charge on a non-flammable surface and never leave batteries charging unattended.

Short Circuit. Never short the battery leads. Keep the connector away from metal objects when the battery is not installed. Never store a loose battery in a pocket, purse, or bag.

Physical Damage. Do not puncture, bend, crush, cut, or deform the pouch. Do not modify the battery or remove its protection circuit. Do not use a battery that is damaged, swollen, or leaking. Do not solder directly to the cell.

Not for Vaping Devices. Do not use with e-cigarettes, vaporizers, or similar devices.

Compatibility. No express or implied guarantee of compatibility with any device beyond those listed is made. Confirm your device’s requirements and connector polarity before use.

Intended Use. This battery powers radio and wireless research hardware. Transmitting with a HackRF requires the appropriate license or authorization and must stay within the frequency bands and power levels you are licensed to use. Wireless security testing tools must only be used on networks and devices you own or have explicit permission to test. The operator is responsible for compliance with all applicable laws.

Transport Certification. This cell is UN38.3 tested and is shipped at approximately 30% state of charge in line with IATA and US DOT lithium battery shipping regulations. The UN38.3 test summary is available upon request to authorities, carriers, and other parties with a legitimate need.

Shipping Restrictions. Lithium batteries sold without equipment are regulated as hazardous materials. This item ships only to addresses in the 48 contiguous United States, by ground service. It cannot be shipped internationally, by air, or to Alaska, Hawaii, or US territories.

Not a Toy. Keep out of reach of children and pets.

Disposal. Do not dispose of in household trash or fire. Recycle at a battery collection or drop-off point in accordance with local regulations.

Resellers. Resellers must forward all warnings to all customers for their reference and safety.

Disclaimer. This product is sold “as-is” for use by qualified individuals. Use of lithium batteries is at your own risk. The buyer is responsible for any damage or injury caused by misuse or mishandling of lithium batteries and chargers. Rabbit-Labs LLC makes no warranty, express or implied, regarding fitness for a particular purpose. Maximum liability shall not exceed the purchase price of the product.


© Rabbit-Labs LLC. All rights reserved. The Rabbit-Labs name and logo are trademarks of Rabbit-Labs LLC. HackRF, PortaPack, ESP32 Marauder, and other product names are trademarks of their respective owners. Rabbit-Labs is not affiliated with or endorsed by them.

Additional information

Weight 0.3 lbs
Dimensions 9 × 6 × 1 in
HSCODE

8507.60.0000

ECCN

EAR99

Withdraw from contract

x

Help Plant Trees with Rabbit-Labs

Donation Added to Cart.

Help Plant Trees with Rabbit-Labs

Click Here to learn about how Rabbit-Labs is helping make an Impact by Planting Trees

We will plant one tree for every tree you plant

 
Select your currency