Learn to Program a microcontroller for less than a cup of coffee 😝!
Want to get into Programming? Hardware? The Arduino UNO has been the staple of both hardware and software hobbyists and hackers for over a decade. Supported by the Arduino IDE, the Arduino is a great way to learn about hardware, or coding, bringing your ideas to life. While this is not an “Official” Arduino UNO, it is based on the open-source design. Unlike many other Arduino clones, this board has been tested and verified by Rabbit-Labs for ease of use, quality, and it’s ability to be plug-and-play without any crazy exotic drivers. Just download the Official Arduino IDE and plug in the board, it’s really that simple, before you know it you’ll be designing your own gadgets!
Microcontroller (MCU):
IC: Microchip ATmega328P (8-bit AVR core)
Clock Speed: 16 MHz (on Uno R1 to R3 boards), though IC supports 20 MHz maximum at 5 Volts
Flash memory: 32 KB, of which 0.5 KB used by the bootloader
SRAM: 2 KB
EEPROM: 1 KB
USART peripherals: 1 (Arduino software default configures USART as a 8N1 UART)
SPI peripherals: 1
I²C peripherals: 1
Operating Voltage: 5 Volts
Board:
Digital I/O Pins: 14
PWM Pins: 6 (Pin # 3, 5, 6, 9, 10 and 11)
Analog Input Pins: 6
DC Current per I/O Pin: 20 mA
DC Current for 3.3V Pin: 50 mA
Size: 68.6 mm x 53.4 mm
Weight: 25 g
ICSP Header: Yes
Power Sources:
USB connector / Barrel Jack / Pin Headers
